My boys share a room – and they’ve been collectively asking for a space room for, well, years. So a few weekends ago, we sent the boys away to their grandparents’ house and surprised them with their new space room.
By far, the coolest part of their new room is this Constellations wallpaper from Coloray.
This isn’t traditional wallpaper. This is actually PEEL-AND-STICK wallpaper. That’s right, folks. Slap it up there, and then when they change their minds or change rooms or if we decide to move – it PEELS RIGHT OFF. And, it’s REUSABLE.
(I am talking in all caps because I have spent a month slowly scraping wallpaper off four walls and THIS IS A BIG DEAL.)
So, yes, this is a life-changing home décor product – but, you do need to know how to hang it properly or you are going to get yourself in trouble. Ask me how I know.
**Note – make sure to remove all jewelry before hanging the wallpaper. We noticed our rings made tiny scratch marks when we first started out – so learn from our mistake!**
Step One – Clean and Prime Your Walls
This is the most important step.
I repeat – the most important step!
Wipe your walls down with a wet cloth (because you know if it’s in a kid’s room, it’s going to be covered in all sorts of grime). If the wall is painted with a latex paint (especially a gloss paint), the wallpaper won’t stick properly. Your best bet is to lay a quick coat of primer on the wall and let it dry completely.
Step Two – Remove Baseboards and Outlet/Light Switch Covers
Our baseboards were a bit tricky to remove in one piece, but we were able to get them off without doing any damage.
Step Three – Lay Out the Wallpaper Panels
Carefully lay out your wallpaper panels on the floor (with clean hands). Make sure the design on the edges line up and double check the length of your wall. If you have slightly more length than you need, you may be able to overlap the panels a bit, as long as the designs still match up.
Step Four – Start Hanging
Once you’ve determined your left-to-right panel order, get ready to hang. Starting at the top of the wall (and working in a left-to-right fashion), peel back the first four or so inches of the backing.
(Note: I would NOT recommend peeling the backing on the carpet or bed or any surface that may have dust or hair on it. The first time we did this on the floor, all kinds of little things immediately stuck to the back of the wallpaper and affected its sticking power in those spots.)
Line up the top of the panel with the top of your wall and press it down, making sure it is straight across. Have someone step back and verify that it’s straight. If not, you can peel if off and try again.
Step Five – Work Your Way Down
You’ll want two people for this step – one person to pull the backing off from behind, about a foot at a time, and one to smooth down the paper by pressing from the middle out to the edges. Smooth out all those little creases and bubbles.
If you’re finding that the paper isn’t laying flat, peel it up a bit and try again. Continue smoothing it down, one foot at a time, until you get to the bottom of the wall.
Step Six – Cut Around Outlets and Light Switches
If you run into an outlet or light switch as you’re laying the paper down, make note of where it is and lay the paper right over it.
Then, before you do anything else – GO TURN OFF THE POWER.
Seriously, don’t try to cut the hole out with the switch power on. Use a flashlight if you must for this part (we did).
Using a sharp utility knife or a single edge razor blade, carefully cut a hole as big as the opening in the drywall. The cover will give you some leeway to work with, so don’t worry about it being perfect.
Step Seven – Cut Off the Excess
Once you reach the bottom of the wall, cut off the excess below where the top of your baseboards will be. (You’ll want a little wiggle room.) Then, press really well and voila! You’ve just finished your first panel.
Step Eight – Repeat Steps One Through Seven
Keep following this process with additional panels until you’ve finished your wall.
You may want to run your hands over it once more to smooth out any additional bubbles. If there’s a tricky spot, you can run a blow dryer over it and then try smoothing it out – this works surprisingly well.
Step Nine – Install Your Baseboard
(Or convince your husband to do it thirty minutes before your kids’ bedtime while you get the kids dressed for bed. I mean, he’s a lucky guy.)
That’s it! So much easier than traditional wallpaper – as long as you follow the important preparation steps.
We chose the Constellations pattern, but there are so many beautiful categories to choose from: